This quick guide will show you the correct way to install a water/liquid cooled harness using the iCAT setting bar (part number 980.2153).
There is also a guide for the air/gas cooled harness.
TIP : Lubricate the o-rings & cable assembly connector first to enable easier installation.
Step 1
- Insert the tool bar through the front of the iCAT and robot arm and screw into the cable assembly.
Step 2
- With the cable assembly correctly positioned, pull it into the module all the way to the end.
Step 3
- When fully inserted, the orange o-ring in the tool bar will be flush with the connecting module interface.
NOTE : When replacing a water/liquid cooled harness, it is important to make sure any coolant residue in the connection module is removed prior to installation.
Thank you once again for reading our blog and I hope you found the information useful.
If you thought this blog was interesting but are looking for more in-depth information on robotic welding torches, we have a guide that's right in your wheelhouse. Read The Definitive Guide to Robotic Welding Torches here or by clicking the button below.